Potensi Sebaran Endapan Placer Berdasarkan Analisis Konfigurasi Reflektor Seismik Menggunakan Seismic Single Channel Pada Perairan Bangka Utara

Al Zaky, Bagus Raihan (2023) Potensi Sebaran Endapan Placer Berdasarkan Analisis Konfigurasi Reflektor Seismik Menggunakan Seismic Single Channel Pada Perairan Bangka Utara. Other thesis, Institut Teknologi Sepuluh Nopember.

[thumbnail of 03411940000055_Undergraduate_Theses.pdf] Text
03411940000055_Undergraduate_Theses.pdf - Accepted Version
Restricted to Repository staff only until 1 October 2025.

Download (14MB) | Request a copy

Abstract

Kepulauan Bangka Belitung memiliki cadangan timah cukup besar, hal ini diakibatkan karena adanya sabuk timah (tin belt) yang membentang dari China, Myanmar, Thailand, Malaysia, Indonesia. Timah dalam bentuk endapan dijumpai dalam dua tipe, yaitu endapan timah primer dan sekunder atau placer. Untuk mengetahui kondisi bawah permukaan dalam kaitan identifikasi zona endapan dilakukan pengukuran metode seismik. Metode seismik didasarkan pada pengukuran respon gelombang yang menjalar pada suatu medium dan kemudian direfleksikan dan direfraksikan sepanjang perbedaan batas batuan. Penelitian ini menggunakan metode seismic single channel dengan instrumen sumber gelombang menggunakan boomer dengan rentang frekuensi 300 Hz - 3 Khz dan resolusi kedalaman kurang dari 200 m. Pengolahan data seismik dilakukan dengan parameter bandpass filter dan predictive deconvolution untuk menghilangkan noise pada data. Interpretasi dilakukan dengan pendekatan konfigurasi reflektor untuk melihat kondisi dan litologi bawah permukaan. Sekuen A merupakan endapan laut dengan konfigurasi dominan parallel dan litologi berupa batulempung. Sekuen B merupakan endapan transisi dan endapan sungai dengan kedalaman dari permukaan laut sebesar 42.9 m dan memiliki konfigurasi reflektor beragam terdiri dari subparallel, divergent, dan chaotic. Berdasarkan analisis konfigurasi reflektor sekuen B merupakan endapan placer dengan litologi berupa perselingan batupasir kasar, batupasir halus, dan batulempung. Bentuk konfigurasi reflektor sekuen B mengindikasikan terjadinya aktivitas pengikisan atau kenaikan dari batuan granit yang membawa mineral kasiterit. Setelah ditentukan zona endapan placer maka didapatkan besaran perkiraan volumetri dari formasi terkait dengan endapan placer yang berada pada sekuen B sebesar 1.395.435.920 m3. Kondisi dasar permukaan laut daerah penelitian memiliki kedalaman 13 - 31 m dengan bentuk dasar permukaan seperti sebuah lembah.
===============================================================================================================================
The Bangka Belitung Islands have sizable tin reserves, this is due to the existence of a tin belt that stretches from China, Myanmar, Thailand, Malaysia, Indonesia. Tin in the form of deposits is found in two types, namely primary and secondary tin deposits or placers. To determine subsurface conditions in terms of identification of deposit zones, seismic method measurements were carried out. The seismic method is based on measuring the response of waves traveling through a medium and then being reflected and refracted along different rock boundaries. This study uses a single channel seismic method with wave source instruments using boomers with a frequency range of 300 Hz - 3 Khz and a depth resolution of less than 200 m. Seismic data processing is carried out with bandpass filter parameters and predictive deconvolution to remove noise in the data. Interpretation is done by reflector configuration approach to see subsurface conditions and lithology. Sequence A is a marine deposit with a parallel dominant configuration and lithology in the form of claystone. Sequence B is a transitional deposit and river deposit with a depth of 42.9 m from sea level and has various reflector configurations consisting of subparallel, divergent, and chaotic. Based on the analysis of the reflector configuration, sequence B is a placer deposit with lithology in the form of alternating coarse sandstones, fine sandstones, and claystones. The shape of the B sequence reflector configuration indicates the occurrence of eroding or uplifting activity from the granite rock which carries the mineral cassiterite. After determining the placer deposit zone, the volumetric estimate of the formation associated with the placer deposit in sequence B is 1,395,435,920 m3. The sea surface condition of the study area has a depth of 13 - 31 m with a basic surface shape like a valley.

Item Type: Thesis (Other)
Uncontrolled Keywords: Endapan Placer, Seismik Single Channel, Konfigurasi Reflektor, Volumetri, Placer Sediment, Seismic Single Channel, Reflector Configuration, Volumetric
Subjects: G Geography. Anthropology. Recreation > G Geography (General) > G70.212 ArcGIS. Geographic information systems.
G Geography. Anthropology. Recreation > GC Oceanography
Q Science > QE Geology > QE538.5 Seismic waves. Elastic waves
T Technology > TC Hydraulic engineering. Ocean engineering > TC175.2 Sediment transport
Divisions: Faculty of Civil, Planning, and Geo Engineering (CIVPLAN) > Geophysics Engineering > 33201-(S1) Undergraduate Thesis
Depositing User: Bagus Raihan Al Zaky
Date Deposited: 15 Aug 2023 07:15
Last Modified: 15 Aug 2023 07:15
URI: http://repository.its.ac.id/id/eprint/104716

Actions (login required)

View Item View Item